Ready to roll

[CFCreations]

Greetings everyone,My name is Mona Im from glendale az. Im here just checking you all out. Im never quite sure what to say as a greeting, its like writing a greeting to some stranger that ends up being in prison or belongs there.

So on that note. I am glad you all let me be a part of this forum. I hope to know all of you.

[bajadog]

Greetings and welcome Mona.

Do you make any CF skid plates?

When you get a chance, be sure to let us know what
you ride, and where.

l8tr

[CFCreations]

I can make CF skid plates.The cost depends upon how many you want. I would have to mold yours to make you a pure CF piece. Molding costs $350 and its $150 per piece. But if you are looking for multiples then I can scratch the molding cost and bring the per piece down. Its hard to make a mold then only sell one, and be stuck with mold that I never use again.

And as for rides. I used to have a Pink GSXR 1000. I was rear ended---You'd think the woman would have seen me. So I dont have a bike at the moment.

[bajadog]

Sorry to read about your ride.

Did you get hurt bad?

[CFCreations]

She didn't hit me to hard. I had a fractured arm, and my knee was twisted. But I am good for the most part.