KTM Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Offroad 4 strokes
    i have purchased new seals and seal carrier (after oil started coming out of weep hole) but cannot get the carrier to seat all the way into the head far enough to get the pin in, i have watched the only video on YouTube of this and followed it correctly, anyone had this problem or know any tricks?.
  2. Duke 690, 390, 125
    I am going to provide a play by play and hopefully some of you can shed light, any information helps. I have a 2016 Duke 390. I live in Toronto Canada so right now it gets to like 9 degreesC. Four days ago I tried starting my bike and it wouldn't turn over, it makes noise trying to turn itself...
  3. Two Strokes
    I bought a 2013 exc.. ran great changed my gas tank and after the bike wouldn't turn over. It just clicked. I've put new starter relay new battery new starter all and still just clicks. I can't roll it off because it has recluse clutches. Any ideas
  4. Offroad 4 strokes
    I have a 2011 ktm xcf 250 that is fuel injected, and it runs like a champ. After doing some tight trails and the bike gets hot it will bog a little on the low end, and it won’t idle. If I pull the cold start knob out it idles, but if that isn’t pulled out it won’t idle. I already tried replacing...
  5. Two Strokes
    Hi there! I’m new to this forum stuff and looking for answers on a swap I’d like to do on my 2002 Ktm 250 sx. Just to get started I’d like to say if my questions seem dumb I’m just a curious 15 year old. I’m not new to motors I’ve been around them my whole life I know a lot about them but...
1-5 of 5 Results