KTM Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
First post and new to the forum. I just purchased a new to us 2018 50SX and there is a couple of times but the carb it weeping gas. It hard to pin point the source, the right side is wet, but no obvious leaks. In tightened up the bowl screws but no luck. Any ideas, I’ve see some similar posts, but no solutions. Thanks.
 

· Super Moderator
Joined
·
3,319 Posts
Welcome to forum. If you take the carbi off the bike you can then take off the Float Bowl, and you can check in what state the gasket is. On the right side you also have the overflow hose. If the float level is not set correctly you could get the overflow coming out the over flow hose. But it should not be able to come on to the carbi, this could only happen if th hose is not properly fitted.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top