KTM Forums banner
  • Hey everyone! Enter your ride HERE to be a part of September's KTM of the Month Challenge!
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hello everyone,

I am trying to find what tension you have to set your Spoke Torque Wrench to verify spoke tension on my 1290 SA.

Manual only says to check by tapping the spoke with screwdriver. Would anyone know the actual Ft-lbs that we need to set?

This seems to be the best kept secret.

Thx
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
OK, just found it. Funny that the service manual does not give you the torque value but the owners manual does. It's 5Nm or 3.7 ft/lbs... Conversion for my TUSK spoke wrench, value is 44.4 in/lbs.
 
1 - 3 of 3 Posts
Top