I'm hoping somebody has had a similar issue and it's an easy fix before I take my bike into the shop. I've tried an oil change and replaced the air filter to start out.
When the engine is just warming up, it will idle between 1200-1500 RPM, and after maybe 30 seconds, the engine will cut off. I turn it back on, and it will happen a couple more times until the engine is warm. Is there a way to adjust the idle RPM? It seems like it would not cut out if the idle RPM was slightly higher.
Another potentially related issue, which seems worse than the first issue is that if I stall the engine from a bad start or something, I have a really hard time getting the engine to start back up. It takes a minute or two of tweaking the gears, rocking it around, messing with the throttle, etc. before it will finally start again. I haven't actually figured out a consistent way to get it started again when the engine gets into that funky state - I just try stuff until it eventually turns over.
The weird thing is that if I don't stall it, and I turn it off normally with the key or shut-off switch, it will start up without a problem.
I'm not sure if the cold idle and stalled engine issues are related, but they seem to have started around the same time.
Any advice or help is useful. Thank you in advance!
When the engine is just warming up, it will idle between 1200-1500 RPM, and after maybe 30 seconds, the engine will cut off. I turn it back on, and it will happen a couple more times until the engine is warm. Is there a way to adjust the idle RPM? It seems like it would not cut out if the idle RPM was slightly higher.
Another potentially related issue, which seems worse than the first issue is that if I stall the engine from a bad start or something, I have a really hard time getting the engine to start back up. It takes a minute or two of tweaking the gears, rocking it around, messing with the throttle, etc. before it will finally start again. I haven't actually figured out a consistent way to get it started again when the engine gets into that funky state - I just try stuff until it eventually turns over.
The weird thing is that if I don't stall it, and I turn it off normally with the key or shut-off switch, it will start up without a problem.
I'm not sure if the cold idle and stalled engine issues are related, but they seem to have started around the same time.
Any advice or help is useful. Thank you in advance!
