[Hairway_to_Steven]

I installed a set of Ledperf sequential indicators, but I also had to order Rizoma loom adapters and small plastic brackets, but the overall fit and quality is perfect.

You got videos or pictures?

 

[Hairway_to_Steven]

Nice look. How do you find their brightness and visibility?

 

[Hairway_to_Steven]

I asked people's opinions in the other LED thread (I have a set of the LEDPerf sequential AND the Euro OEMs here, and am debating which to install), and the consensus there seemed to be to go with OEM. I am still undecided. I confess I like the small, mean look of the LEDPerf units, and the sequential feature is very neat.

 

[Hairway_to_Steven]

I think maybe I'll connect one of each to a battery and see how they look. Maybe post a video.

 

[Hairway_to_Steven]

And you would say the brightness is comparable? "After all, safety is paramount," said the guy riding the 180 hp two-wheeled rocket ship at stupid speeds.

 

[Hairway_to_Steven]

Looks pretty good! Certainly very snazzy design.

 

[Hairway_to_Steven]

What's with the sweat band on the brake reservoir?

 

[Hairway_to_Steven]

I have Ledperf on my Gen3.
No resistors required.
i spliced them into the existing harness, testing polarity as i went. Polarity matters, but trial and error works fine. If you get em wrong just reverse before soldering and heat shrinking.

I’d tell you which wires are which, if I remembered, which I don’t. But I remember it being counterintuitive.

 

[Hairway_to_Steven]

Everything seemed to work fine, because I tested them using the hazard switch with engine off. I had heard tales of the system griping if there was a mismatch front to back, but I did not experience it.

Edit: it was a pretty easy install. The hardest part was lifting the tank to get at the front connector pouch.

 

[Hairway_to_Steven]

NICE! Good job. Like you, I had no gripe from the system when half the bulbs were swapped. But I didn't ride it that way - I changed everything in one go.

 

[Hairway_to_Steven]

Nicely done. I love these indicators.

 

[Hairway_to_Steven]

Thanks. Never heard of them until your mention. The sequential effect is very cool!

Well, in that case I am extra happy that you are pleased with them. I’d hate to be responsible for the immiseration of a fellow member. I certainly have been pleased with mine.

 

[Hairway_to_Steven]

I haven’t, but I can give you the measurements across the signal lights with an Evotech tail tidy, if that would be helpful

 

[Hairway_to_Steven]

Ok stay tuned.

 

[Hairway_to_Steven]

The span is 13.75 inches from tip to tip. if you want other measurements I’ll do my best